CTRB Greaseseal Press Machine

CTRB Grease Seal Machine


     1. Read the operation manual thoroughly and understand the finer points of the Equipment.
     2. Keep the equipment meticulously clean.
     3. Use only the recommended grade of clean oil.
     4. The oil should always be maintained at the marked level. If the oil level is less, then it may damage the pump.
     5. Use only those accessories which are mechanically in sound condition. Damaged or worn out accessories may cause
        heavy consumption of oil and sealing components and will affect the service life of the equipment.
     6. Protect attached power cables from physical damages.
     7. Loose electric connections and cable joints should be avoided.
     8. Before switching on the equipment, check the power supply.


     1. Do not use contaminated or dirty oil. Do not mix different Grades/Brands of oil.
     2. Do not ever use cotton waste to clean the oil tank or any of the Hydraulic Components.
     3. Do not start the power - pack under load conditions.
     4. Do not allow to change the factory calibrated pressure settings without consulting the manufacturer.
     5. Do not attempt to weld and repair damaged or worn out parts/accessories.
     6. Do not start the power - pack if the oil level is low. It may damage the pump.
     7. Do not run the power - pack if not required, even in the unloaded condition. It will save energy.
     8. Do not make loose electrical connections. It may lead to single phasing and the electric motor windings
        may get damaged.